Just installed my demon, coolrunner wired for RGH2 and 256 BB upgrade kit installed but when i try to read the xbox360 nand i get an error: Unknown NAND-flash device id 0xFF02 reported. D I need to solder any extra wires on the demon other than the standard installation route? Any ideas? Thanks in advance.
TX Product(s) used: CR Rev C
Console Type: Jasper 256mb
NAND size: 256
Dashboard version: latest? 12/13/13
CB version: e.g 5771
Screenshot of NAND details from J-Runner:
(attach an image to your post)
J-Runner log: Checking Files
Finished Checking Files
Reading Nand to C:\Documents and Settings\Jeff\My Documents\Downloads\output\nanddump1.bin
Failed to grab handle
updflash.bin log (if applicable):
Image of Coolrunner:
Images of close-up soldering to motherboard:
(attach images to your post)
Description of problem: Can't read NAND with demon with standard installation and bb upgrade
Was the console working before you started: Yes with a retail nand
dt.JPG
photo (2).JPGphoto (3).JPGphoto.JPGphoto (1).JPG
TX Product(s) used: CR Rev C
Console Type: Jasper 256mb
NAND size: 256
Dashboard version: latest? 12/13/13
CB version: e.g 5771
Screenshot of NAND details from J-Runner:
(attach an image to your post)
J-Runner log: Checking Files
Finished Checking Files
Reading Nand to C:\Documents and Settings\Jeff\My Documents\Downloads\output\nanddump1.bin
Failed to grab handle
updflash.bin log (if applicable):
Image of Coolrunner:
Images of close-up soldering to motherboard:
(attach images to your post)
Description of problem: Can't read NAND with demon with standard installation and bb upgrade
Was the console working before you started: Yes with a retail nand
dt.JPG
photo (2).JPGphoto (3).JPGphoto.JPGphoto (1).JPG