Ok lets try this again.
I have the R-Jtag installed and the computer recognizes it. The 1st problem I m having is when I click read Nand I get an error,
I have the up to date dashboard
I re-soldered the wires and still the same thing. Now I'm not sure if I was suppose to do anything else prior to this.
Steps taken so far,
Installed all components of R-Jtag Ultimate
Turn on computer, computer recognizes JR programmer.
The rest is in the wind.
What tutorial should be followed when Glitching this box?
One thing I should note is when I plug the power to the Xbox in the Xbox starts right up. It will not power off unless I pull the plug.
Pictures attached.
oDwxW6Y.jpgD010flv.jpgfWjHozD.jpge4HMPej.jpg
LhPcVZp.jpg3YzzWUC.jpgmKqBuve.jpg
Thank you to all that can help
I have the R-Jtag installed and the computer recognizes it. The 1st problem I m having is when I click read Nand I get an error,
Code:
J-Runner v0.2 Beta (289) Started
Filechecks disabled - No Filechecks carried out
Version: 10
Flash Config: 0x00000000
Can not ContinueI re-soldered the wires and still the same thing. Now I'm not sure if I was suppose to do anything else prior to this.
Steps taken so far,
Installed all components of R-Jtag Ultimate
Turn on computer, computer recognizes JR programmer.
The rest is in the wind.
What tutorial should be followed when Glitching this box?
One thing I should note is when I plug the power to the Xbox in the Xbox starts right up. It will not power off unless I pull the plug.
Pictures attached.
oDwxW6Y.jpgD010flv.jpgfWjHozD.jpge4HMPej.jpg
LhPcVZp.jpg3YzzWUC.jpgmKqBuve.jpg
Thank you to all that can help