hello all, im going to be RGHing my corona soon and I have a question on bridging of r2c4,r2c10,r2c6,and r3c7 points. first is the bridging needed for (r2c10) if I use demon for nand read and write? Also when bridging or jumping does anyone use wires or just bridge with solder? r2c4 bridging for rater use, im going to use proto v2, I see a lot of post with great boot times on install without tinkering. so is it needed? lastly, theses bridges if needed or used are they removed after tuning and install?
thanks
thanks