This is based off the following thread as i dont know if it would be appropriate to revive a dead thread or not:
http://team-xecuter.com/forums/showt...=Jrunner+crash
I would also like to note i have got a thread complaining about the same issues prior located here:
http://team-xecuter.com/forums/showthread.php?t=139137
the attachment is a copy of my LOG file in the jrunner programs folder since last september.
I have YET to get J-runner to dump or flash a NAND for me as of some time in september 2013, i would also like to note i DID NOT install this myself it was sent to a pro-moder here at the site so soldering should not be an issues i have also managed to get one good set of reads and flashes....but nothing after that.
I have gotten to the point where I have figured out exactly what to do to get the demon to detect in windows and all of that, but by no means (and this is my third or fourth time messing with the same system across 3 different computers now) can I get jrunner to even THINK about starting to dump the NAND on either the DemoN or the 360 its self (aside from one lucky instance).....debating on trying a firmware update for my DemoN as it is still on FW 1.00....but in this state im scared shitless Ill ruin something and not be able to reflash any thing.
Things that work best for me are as follows:
Unplug EVERYTHING
Plug in console
Switch Demon to retail (blue light off)
Plug in USB cord to daughter board (now windows sees it as a Demon not an undetectable USB device)
Try to run Jrunner try to dump NAND and watch it crash and shut down
Repeat previous steps and go in continuous circle chasing my tail because Im lost
Any help or Ideas to help other than ones that have already been suggested? Im about ready to loose it here.
http://team-xecuter.com/forums/showt...=Jrunner+crash
I would also like to note i have got a thread complaining about the same issues prior located here:
http://team-xecuter.com/forums/showthread.php?t=139137
the attachment is a copy of my LOG file in the jrunner programs folder since last september.
I have YET to get J-runner to dump or flash a NAND for me as of some time in september 2013, i would also like to note i DID NOT install this myself it was sent to a pro-moder here at the site so soldering should not be an issues i have also managed to get one good set of reads and flashes....but nothing after that.
I have gotten to the point where I have figured out exactly what to do to get the demon to detect in windows and all of that, but by no means (and this is my third or fourth time messing with the same system across 3 different computers now) can I get jrunner to even THINK about starting to dump the NAND on either the DemoN or the 360 its self (aside from one lucky instance).....debating on trying a firmware update for my DemoN as it is still on FW 1.00....but in this state im scared shitless Ill ruin something and not be able to reflash any thing.
Things that work best for me are as follows:
Unplug EVERYTHING
Plug in console
Switch Demon to retail (blue light off)
Plug in USB cord to daughter board (now windows sees it as a Demon not an undetectable USB device)
Try to run Jrunner try to dump NAND and watch it crash and shut down
Repeat previous steps and go in continuous circle chasing my tail because Im lost
Any help or Ideas to help other than ones that have already been suggested? Im about ready to loose it here.