I finished 2 Corona V4 4GB last night with Proto V2
Setup
CPU RST Blue wire 10cm to FT3T10 on both
POST OUT Yellow wire stock length think its 10cm on both to 50 on post_out fix adapter v2
switches
one was 3 and 8
other was 4 and 8
Boots instant to 3-4 glitches with USB and XBOX 360 HDD installed, no other changes to Proto V2. Was good enough for me. Xell booted on both in 1-2 glitches when I had put on the ECC. Picture posted, sorry I didn't clean flux off yet before taking picture. I seen the someone else picture and liked where they had soldered their ground.
coronav4.jpg
Setup
CPU RST Blue wire 10cm to FT3T10 on both
POST OUT Yellow wire stock length think its 10cm on both to 50 on post_out fix adapter v2
switches
one was 3 and 8
other was 4 and 8
Boots instant to 3-4 glitches with USB and XBOX 360 HDD installed, no other changes to Proto V2. Was good enough for me. Xell booted on both in 1-2 glitches when I had put on the ECC. Picture posted, sorry I didn't clean flux off yet before taking picture. I seen the someone else picture and liked where they had soldered their ground.
coronav4.jpg