No boot with RGH demon enabled .xsvf file

Hi,
I have a Corona V3.
Install CR3Lite with timing file 3-2 boot time is under 30sec.

I install demon. It's my first demon install. I dont have a QSB so i solder wires between demon and MB points.
Stock Nand is on XBOX flash and RGH nand is on demon.

When i try to boot RGH with timing file 3-2 (without demon enabled) it is booting under 30sec, but when i change to boot from stock, then CR3 is glitching and after some time RED light is coming up on front-panel. I read many post and it is normal, when not demon enabled xsvf file is programed to CR3Lite.
When i put the demon enabled 3-2 timeing file, then stock nand boot's up instanty (without glitching), but demon nand with RGH is glitching endlessly.

What is wrong ? What can I try ?
My Demon and CR3Lite install images :DSCF7887.JPGDSCF7893.JPG

Attached Images

• DSCF7887.JPG (903.2 KB)
• DSCF7893.JPG (915.2 KB)