TX Product(s) used: SLIM PROTO V2, CORONA POSTFIX ADAPTER V2 (not installed yet), Corona 4GB NAND RW KIT V4 (not installed yet)
Console Type:Corona V6
NAND size: 4GB
Dashboard version: -
CB version: -
Images of close-up soldering to motherboard:
20140502_165932.jpg20140502_170130.jpg20140502_170257.jpg20140502_165832.jpg20140502_170444.jpg
Description of problem:
I'm new to RGH. I'm in the middle of connecting all the points, but I would like to make sure that, so far I have the correct connections. Especially 5v, E and F. I'm not sure if you can see from the picture, but no matter what I do, I cannot separate E from F. The solder connects them together. Is that going to be a problem?
Also, I already followed the installation guide for Slim Proto from http://team-xecuter.com/forums/showthread.php?t=139308, but I can't seem to figure out what to do with the POSTFIX adapter and NAND RW KIT..... Is there a guide somewhere? I search through the forum for a while, couldn't see anything but the picture of other people's setup.
Was the console working before you started: Y
Console Type:Corona V6
NAND size: 4GB
Dashboard version: -
CB version: -
Images of close-up soldering to motherboard:
20140502_165932.jpg20140502_170130.jpg20140502_170257.jpg20140502_165832.jpg20140502_170444.jpg
Description of problem:
I'm new to RGH. I'm in the middle of connecting all the points, but I would like to make sure that, so far I have the correct connections. Especially 5v, E and F. I'm not sure if you can see from the picture, but no matter what I do, I cannot separate E from F. The solder connects them together. Is that going to be a problem?
Also, I already followed the installation guide for Slim Proto from http://team-xecuter.com/forums/showthread.php?t=139308, but I can't seem to figure out what to do with the POSTFIX adapter and NAND RW KIT..... Is there a guide somewhere? I search through the forum for a while, couldn't see anything but the picture of other people's setup.
Was the console working before you started: Y