TX Product(s) used: J-R Programmer, RGX 1.0
Console Type: Corona v1
NAND size: 16mb
Dashboard version: 16747
J-Runner log:
Flashing ecc:
Version: 01
Flash Config: 0x00043000
Writing Nand
Corona_16MB_Xell.ecc
Done!
in 0:29 min:sec
Programming Coolrunner
G:\Xbox\common\xsvf\RGX_CORONA_C_CR_EN_P50.xsvf
USB XSVF Player Initialized
Xilinx XC2C128-VQ100 ......... [DETECTED]
Erase Succeeded
File: G:\Xbox\common\xsvf\RGX_CORONA_C_CR_EN_P50.xsvf
Sending Out Packets .........
Success
Description of problem:
Was the console working before you started: Y
Do you get a green debug light appear on the RGH chip every 4-5 seconds: Y
How long is the light on for each time: 3 seconds
So i've started with my second key extraction on the corona and i have some problems.
The RGX keeps glitching but wont ever boot in Xell, i've tried every RGX file (A, B, C) and different wire lengts for CPU_RST and POST_OUT
On the post_out i have a 54cm Kynar wire (green wire in picture)
And on the CPU_RST a 10 CM wire
I've cleaned up my previous solderings and soldered it back. But thats not working either.
There are also no bridged to be found on the board.
I've flashed the Original nand back a few times to check if the xbox was still working and it does!
Console Type: Corona v1
NAND size: 16mb
Dashboard version: 16747
J-Runner log:
Flashing ecc:
Version: 01
Flash Config: 0x00043000
Writing Nand
Corona_16MB_Xell.ecc
Done!
in 0:29 min:sec
Programming Coolrunner
G:\Xbox\common\xsvf\RGX_CORONA_C_CR_EN_P50.xsvf
USB XSVF Player Initialized
Xilinx XC2C128-VQ100 ......... [DETECTED]
Erase Succeeded
File: G:\Xbox\common\xsvf\RGX_CORONA_C_CR_EN_P50.xsvf
Sending Out Packets .........
Success
Description of problem:
Was the console working before you started: Y
Do you get a green debug light appear on the RGH chip every 4-5 seconds: Y
How long is the light on for each time: 3 seconds
So i've started with my second key extraction on the corona and i have some problems.
The RGX keeps glitching but wont ever boot in Xell, i've tried every RGX file (A, B, C) and different wire lengts for CPU_RST and POST_OUT
On the post_out i have a 54cm Kynar wire (green wire in picture)
And on the CPU_RST a 10 CM wire
I've cleaned up my previous solderings and soldered it back. But thats not working either.
There are also no bridged to be found on the board.
I've flashed the Original nand back a few times to check if the xbox was still working and it does!