Hello guys, I recently installed a coolrunner on my xbox and a qsb upgraded (with the crystal) as of trying to do rgh 2 to my console since its a corona v1. From the begining everything went smooth, even the soldering. I started my j-runner and hooked it up with the JR programmer v2 and from there to the qsb upgraded. I pressed F2 on the computer and gave me just what I was expecting:
flash config 0x00043000
CB version 13181
Corona
(I guess this means the soldering is good)
Then I read the nands without problems, created the .ecc and wroted to the nand.
Then I programed my coolrunner with the timing file.
But when I went to test it, it simply didn't show the green light at all.
I was wondering if this is a boot time issue?
Should I try some combinations?
Is there any other issue that might be causing the coolrunner not to show its green light?
This is all I'm working with:
Corona v1
JR programmer
QSB corona upgraded
J-Runner
CR rev C
(JP closed 3-2 closed too, switched to slim, cpu_rst is the 55 cm long blue wire)
Thanks
flash config 0x00043000
CB version 13181
Corona
(I guess this means the soldering is good)
Then I read the nands without problems, created the .ecc and wroted to the nand.
Then I programed my coolrunner with the timing file.
But when I went to test it, it simply didn't show the green light at all.
I was wondering if this is a boot time issue?
Should I try some combinations?
Is there any other issue that might be causing the coolrunner not to show its green light?
This is all I'm working with:
Corona v1
JR programmer
QSB corona upgraded
J-Runner
CR rev C
(JP closed 3-2 closed too, switched to slim, cpu_rst is the 55 cm long blue wire)
Thanks