My Falcon JTAG had a 15xxx dash on it, cant remember which one at the moment, sorry, and it RROD on me about a month ago. Havent had time to reflow it with my workstation, but I'm about to RGH a MW3 Corona v1 and would like to move it to that one when its done.
Is there really much I need to do to the drive to move it over, as far as software goes? It's a 2TB hard drive and I really dont feel like reloading all that back onto a drive for the Corona.
I'm assuming that after I flash the 16203 RGH NAND onto the Corona, I can then just plug in the HDD and if it needs to update any files it will. I've used this HDD between another old Xenon JTAG and the Falcon JTAG back and forth before with no problems, but I just want to make sure.
Thanks
Is there really much I need to do to the drive to move it over, as far as software goes? It's a 2TB hard drive and I really dont feel like reloading all that back onto a drive for the Corona.
I'm assuming that after I flash the 16203 RGH NAND onto the Corona, I can then just plug in the HDD and if it needs to update any files it will. I've used this HDD between another old Xenon JTAG and the Falcon JTAG back and forth before with no problems, but I just want to make sure.
Thanks