Hello..
having a bit of a tough time with this corona .. need some input pls.
corona v2 - no post
4gb nand
dash 16203
CB 13181
10cm blue wire to cpu_rst (have also tried to smc_rst)
7.png
j-runner crashed after dumping nand so I don't have full log.. opened nand after for pic and comparison log
rater.png
pics of my install including resistance check of post out to ground
2.jpg6.jpg5.jpg4.jpgohms.jpg
console was working before I started... now the DBG light blinks on and off but will not boot xell.. I have nand-x usb update cable hooked up to qsb v3 and have monitor com running with the right port open - at times I have also had rater running .. have tried all the dip switches ... have not tried any caps ... have tried 5 and 50 for post out lenght.. any tips would be greatly appreciated.. thanks
having a bit of a tough time with this corona .. need some input pls.
corona v2 - no post
4gb nand
dash 16203
CB 13181
10cm blue wire to cpu_rst (have also tried to smc_rst)
7.png
j-runner crashed after dumping nand so I don't have full log.. opened nand after for pic and comparison log
Code:
Tuesday, August 13, 2013 9:30:46 PM
J-Runner v0.2 Beta (289) Started
WARNING! - Your selected working directory already contains files!
You can view these files by using 'Show Working Folder' Button
Checking Files
Finished Checking Files
Initializing nanddump1.bin..
Nand Initialization Finished
Writing to J:\ from C:\Users\ch@se\Desktop\J-Runner v02 (278) Core Pack\common\ECC\CORONA_4GB.ecc
Done!
in 0:01:721 min:sec:ms
Could not find a part of the path.
===================================================
Tuesday, August 13, 2013 11:20:13 PM
J-Runner v0.2 Beta (289) Started
WARNING! - Your selected working directory already contains files!
You can view these files by using 'Show Working Folder' Button
Checking Files
Finished Checking Files
Initializing nanddump1.bin..
Nand Initialization Finished
Comparing...
Can't check for bad blocks. No Spare data. Possibly Corona 4GB
Can't check for bad blocks. No Spare data. Possibly Corona 4GB
Nands are the samerater.png
pics of my install including resistance check of post out to ground
2.jpg6.jpg5.jpg4.jpgohms.jpg
console was working before I started... now the DBG light blinks on and off but will not boot xell.. I have nand-x usb update cable hooked up to qsb v3 and have monitor com running with the right port open - at times I have also had rater running .. have tried all the dip switches ... have not tried any caps ... have tried 5 and 50 for post out lenght.. any tips would be greatly appreciated.. thanks