Hey guys. I have a problem that I can't figure out. I attempted to create my own sound for my Trinity but it didn't go so well lol. It may be just a coincidence but after I flashed it the sound went dead and I'm getting the following error.
Prior to me flashing my custom one, I didn't have any issues at all reading or writing.
I've done some research on the error but I didn't come up with a solution. I don't know anything about the flash device used so I don't know if it's possible for it to have a bad flash and if there's a way to reset it. I can replace the chip if needed but before I go through the trouble I thought I'd ask if anyone has had a similar problem.
edit: I should mention that I'm using a JRP v2.
Code:
Sending Flash Init...
Status: 0x0
SPI Init Failed !I've done some research on the error but I didn't come up with a solution. I don't know anything about the flash device used so I don't know if it's possible for it to have a bad flash and if there's a way to reset it. I can replace the chip if needed but before I go through the trouble I thought I'd ask if anyone has had a similar problem.
edit: I should mention that I'm using a JRP v2.